fittings needed for afpr?

[GSXLR8]

JP, I am told this is something you could answer but I figured others might have some input.

for an aeromotive afpr
what parts are needed to install into a 2g?

I would like to get my parts from summit because ive got a gift certificate from there that I need to use.

I remember seeing a vfaq on this at one time but for one, it used a discontinued b&m fuel filter (no longer available) and it didnt consider what was needed on the return end of the fuel system (the afpr)

[Mike C]

I don't have a parts list, but I'll offer a couple suggestions. First get a 1g fuel rail. They are about 1" shorter on the return side so you'll have more room to make the 90 degree bend at the T belt cover. The hardest part is drilling and tapping the return side for an AN adapter. You want to get a 3/4-16 - AN adapter. 8AN is the same thread pitch as 3/4-16 pipe thread but stick with the pipe thread at the rail side because it will fit up alittle snugger and comes with an O ring seal. After you tap the rail and put the fitting in then you need a low profile 90 elbow and then what ever AN fitting you want to run into the Aeromotive. Some have 6AN ports and some have 10AN it just depends on which one you got. I think both Earls and Aeroquip make the low profile 90s. I can get you some part numbers if you can't find them.

Mike