1g in a 2g

[trbotln]

Im sure this has been answered many of times know but ill ask again i was just wondering whats the difficulty putting a 1g motor in my 2g?how much would this cost?knock on wood i dont have cw (but havent measured yet)but if i do along the way this would be my route any info helps thanks.

[biglipps66]

I wont go into too many details

But minimal of 1k in work..
Labor... that all depends...

Hack a motor mount, get a flywheel and a 91 TB and intake mani, the complete motor, make a wiring harness, for a 95 ecu change the injector orders and finally swap the firing order if also a 95 ECU.

[Mike C]

http://www.magnusmotorsports.com/
Click on tech articles.

[BlackTalon]

i just read the article in modified mag. they make it seem so easy. 3 steps? remove old motor, put in new motor, start engine? yeah right. why couldn't they go a little more in depth?

[neco]

That's like asking how many licks it takes to get to the center of a tootsie pop. wtf

[BlackEclipse]

I will most likely be doing one within the next 6 months and you all know I will photograph and document the hell out of what I will be doing. I think most people are concerned with all the custom fabrication and custom wiring and the little information that always seems left out whenever you read articles about how to do it.

Like...I wanna see a photograph of the small custom wiring harness that has to be fabricated fully assembled and laying on the ground before it is installed on the engine. All I see on the internet is several different wiring diagrams yet no picture of the end product. Whoever made the diagram...how do we know if they actually put one together themselves or maybe it was just a theory and they never actually did it???

I saw parts of John Lippians install done on his car and I have more confidence now in doing it myself.

[Iwishiwascool]

we could take pics of mine as well while the motor is out